Morningstar SunSaver SS-10L-12V Charge Controller LVD 10A 12V

Morningstar's SunSaver is the world's leading small solar controller for both professional and consumer applications including standard features and capabilities not found in any other small PV controller. -- SunSaver's technology provides: - Exceptional Reliability - PWM Battery Charging - Consistent High Quality - 100% solid state - Series design (not shunt) - True 0 to 100% PWM duty cycle - Setpoint accuracy to 35 mV - Rated for 25% overloads - Fully encapsulated in epoxy potting - Marine rated terminals / anodized case - Temperature compensation - Sealed / Flooded battery select - No need to derate - Parallel for 40 amps or more - Green charging / Red LVD indicators -- Mechanical Specifications: - Wire size #10 AWG (5.2 mm2) - Note: Some #10 spade connectors may not fit terminals - Anodized aluminum case - Marine rated terminals - Epoxy encapsulated - Weight is 8 oz (0.23 kg) -- Electrical Specifications: 12 Volt System - 25 Volt Max PV - Rated Solar Input: 10A - Rated Load: 10A - Max array short circuit current 12.5A - 25% Current Overload 5 min. - Regulation Voltage: Sealed Battery 14.1 V 28.2 V - Flooded Battery 14.4 V 28.8 V - Temp. Comp. (mV/ C) -28 -56 - Self-consumption 6 to 10 mA - Operating Temp. -40 to +85 C -- Reverse Current Protection: The SunSaver prevents the battery from discharging through the PV array at night. There is no need to install a blocking diode for this purpose. -- Noise: The SunSaver circuit minimizes switching noise and filters all noise output to extremely low levels when the system is properly grounded. If noise is present in a telecom load, it is most likely a grounding problem in the system.

• Low voltage disconnect when battery voltage drops below 11.5v

• Constant voltage pulse width modulation (PWM) charging

• Epoxy encapsulated electronics ensure durability and longevity

• Includes a temperature compensation sensor

• Rated Solar & Load Current: 10A @ 12V